Changing an agricultural 17cu ft pull-behind can be a daunting task, but with the right tools and a little know-how, it can be done in a matter of hours. Here are the steps you need to follow to change an agricultural 17cu ft pull-behind:
Locate the correct tools. You will need a jack to lift the trailer, a wrench to remove the bolts, and a pair of pliers to remove the cotter pins. Once you have the tools you need, locate the trailer’s axle. The axle is the metal bar that runs across the bottom of the trailer. The bolts that hold the wheels onto the trailer will be located on the axle.
Loosen the bolts. Use the wrench to loosen the bolts that hold the wheels onto the trailer. Do not remove the bolts completely. Once the bolts are loose, use the jack to lift the trailer. Be sure to place the jack in a stable location under the trailer’s frame. Once the trailer is lifted, you can remove the bolts and wheels.
How to Change Agricultural 17cu Ft Pull Behind
Changing an agricultural 17cu ft pull behind can be a difficult task, but it is possible to do it yourself with the right tools and a little bit of patience. Here are the steps on how to change an agricultural 17cu ft pull behind:
- Gather your tools. You will need a wrench, a socket set, and a pry bar.
- Disconnect the pull behind from the tractor. This is typically done by removing the two bolts that connect the pull behind to the tractor’s drawbar.
- Raise the pull behind off the ground using a jack or a hoist. This will give you access to the underside of the pull behind.
- Locate the four bolts that connect the drawbar to the pull behind. These bolts are typically located on the underside of the pull behind, near the front of the frame.
- Remove the four bolts using a wrench or a socket set. This will release the drawbar from the pull behind.
- Pull the drawbar out of the pull behind. The drawbar should slide out easily once the bolts have been removed.
- Install the new drawbar. The new drawbar should slide into the pull behind easily. Once the new drawbar is in place, secure it with the four bolts that you removed in step 5.
- Lower the pull behind back onto the ground. Once the pull behind is back on the ground, you can reconnect it to the tractor.
People Also Ask
How do I know if my agricultural 17cu ft pull behind needs to be changed?
There are a few signs that your agricultural 17cu ft pull behind may need to be changed. These signs include:
- The drawbar is bent or damaged.
- The pull behind is difficult to pull.
- The pull behind makes a lot of noise when it is being pulled.
How often should I change my agricultural 17cu ft pull behind?
The lifespan of an agricultural 17cu ft pull behind will vary depending on how often it is used and how well it is maintained. However, most pull behinds will need to be changed every 5 to 10 years.
How much does it cost to change an agricultural 17cu ft pull behind?
The cost of changing an agricultural 17cu ft pull behind will vary depending on the make and model of the pull behind, as well as the labor costs in your area. However, you can expect to pay anywhere from $500 to $1,000 for a new pull behind.
